Pilz PSSu E PD1 User Manual download pdf (Page 21)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-1

6.1 General wiring guidelines

6 Wiring

66000WiringWiring6-6.1General wiring guidelines6100General wiring guidelines6-][Verdrahtung BA Einleitung

Please note:

][Verdrahtung PD1

 Safe electrical isolation must be ensured for the external supplies.

Failure to do so could result in electric shock.

 The external power supplies must comply with the current applicable

standard EN 60950-1, EN 61140, EN 50178 or EN 61558-1.

 The maximum current load on the connection terminals is 4 A per

supply.

 Permitted infeed at the module's connection terminals:

–PE

–0V

–Shield

– - 30 VDC ... + 30 VDC

– - 48 VAC ... + 48 VAC

 Use copper wiring.

][Verdrahtung Zusatz ohne C

 The terminal configuration as stated on the front plate applies for base

modules without C-rail. The terminal configuration as stated in the

technical documentation applies for all other base modules.

6.1.1 Mechanical connection of the base modules

Mechanical connection of the base modules6-][Modulverdrahtung mech

Procedure:

 Use a flat blade screwdriver (DIN 5264-A)!

 Strip the wire back 8 mm.

 If necessary, label the connection level with a colour marker [3].

 Base module with screw terminals:

– Use a screwdriver to loosen the screw on the screw terminal [1]

– Insert the stripped cable into the round fixing hole [2], as far as it

will go.

– Tighten up the screw on the screw terminal.

– Check that the cable is firmly seated.

DIN 5264-A

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

No comments

Pilz PSSu E PD1 User Manual Page 21