Pilz PSSu H SB IBSe User Manual download pdf (Page 25)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-1

7.1 Messages

7 Operation

77000OperationOperation7-7.1Messages7100Messages7-][BA_Betrieb Meldun gen SB p

All errors and faults detected by the electronic modules on a PSSu are

signalled to the head module and entered in the head module's error

stack. You can read the head module's error stack using the

PSS WIN-PRO system software (SafetyBUS p, Domain 0).

][BA_Betrieb Tabelle Meldungen FS+ST Sys A

Module error Statement Remedy

Start-up error Error as the PSSu system starts up Change faulty module

Configuration error Incorrect module type configured The configured hardware registry does

not match the actual hardware registry

FS communication error Error during FS communication Change faulty module

ST communication error Error during ST communication Change faulty module

Bus termination error There is no terminating plate or there is

a bad contact with the module bus

Install a terminating plate with inte-

grated end bracket or insert the base

modules together correctly

Temperature error: too warm (

) Ambient temperature too high:

Error stack entry

Ensure there is sufficient ventilation in

the control cabinet or prevent over-

load

Temperature error: too hot (

) Ambient temperature too high:

Reset the module and stop the affect-

ed I/O-Groups (SafetyBUS p)

Ensure there is sufficient ventilation in

the control cabinet or prevent over-

load

Output error Error during cyclical output test for

short circuit. Possible causes: Short

circuit, or output defective

Rectify the short circuit or change the

faulty module

Test pulse error Possible causes: Short circuit be-

tween a test pulse and a supply volt-

age, or a defective module

Rectify the short circuit or change the

faulty module

Relay control error Error during cyclical monitoring test of

the relay coils

Change faulty relay module

Relay error A relay position is faulty;

possible cause: Defective relay con-

tact

Change faulty relay module

Block switching output error Error during cyclical monitoring test of

the relay contacts;

possible external cause: Voltages be-

ing fed back to the relay contacts

Check the supply voltage and the wir-

ing

Error in the feedback loop FS input detects an error in the feed-

back loop or FS input is defective

Check FS input, check the configura-

tion of the feedback loop, check the

signals, or check the wiring and con-

tacts

Error in the local enable principle FS output has reacted incorrectly or

unexpectedly

Check the configuration of the FS out-

put, or check the fieldbus signals in

the FS and ST section

Input error Error during the cyclical input test;

possible cause: Input defective

Change faulty module

Overload/short circuit Load on output too high Rectify overload or short circuit

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 38 39

Comments to this Manuals

No comments

Pilz PSSu H SB IBSe User Manual Page 25

Comments to this Manuals

Related products and manuals for Sensors Pilz PSSu H SB IBSe